Speedmaster®
Ford 9" 28 Spline 24.000 in. Cut-to-Fit Axle Shaft - Small Bearing
Overview
Speedmaster axles are manufactured using cutting-edge technology and techniques. These forged steel axles are designed to fit a range of applications and are non-tapered with hardened bearing seats. These axles are available in any length up to 34 inches, and they may be reduced to fit if you decide to narrow your rear-end later on.
Specs
| Brand: | Speedmaster |
| Part Number: | PCE201.1010 |
| Part Type: | Axle Shafts, Custom Built |
| Inner Axle Splines: | 28 |
| Axle Type: | Flanged |
| Axle Material: | 4140 steel |
| Axle Length (in): | 24.000 in. |
| Wheel Stud Type: | Press-in |
| Wheel Stud Pattern: | Dual 5 x 4.50 in. and 5 x 4.75 in. |
| Spool Included: | No |
| Wheel Studs Included: | No |
| Bearings Included: | No |
| Seals Included: | No |
| Quantity: | Sold individually. |
| Notes: | Cut to length design 10 in. of spline. Axle Sleeve (PCE420.1007) required to set axle back space. |
Description
| Size | Imperial | Metric |
| A: | 2.811 in. | 71.40mm |
| B: | 1.874 in. | 47.6mm |
| C: | 24.000 in. | 609.6mm |
| D: | 1.378 in. | 35mm |
| E: | 5.905 in. | 150mm |
| X: | Axle Sleeve to offset bearing to your specific application. | |
Note: When used in Ford 9" Differential our recommendation is to use 1x 34" long axle and 1x 30" long axle.
Prop 65 Warning
This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.