Speedmaster®
Weld On 3" and 3.5" 4340 Driveshaft Transmission Yoke 1350
Product Information
Specs
| Brand: | Speedmaster |
| Part Number: | PCE216.1024 |
| Part Type: | Drive Shaft Tube Weld Yoke |
| Yoke Inner Spline Quantity: | N/A |
| Yoke Material: | Chromoly |
| Yoke Overall Length (in): | 4 in. |
| Universal Joint Style: | 1350 Series |
| U Joint Cap Diameter (in): | 1.188 in. |
| Center of U joint to end of slip (in): | 3.5 in. |
| Spline Size (in): | N/A |
| Universal Joints Included: | No |
| Bearing Caps Included: | No |
| Bearing Straps Included: | No |
| Quantity: | Sold individually. |
| Notes: | Uses outside snap rings. Stepped design allows usage with 3" and 3.5" diameter driveshaft tubes. |
Description
When performing your transmission swap, don't forget to get the correct transmission yoke for your application. Speedmaster yokes allow the use of larger-than-stock U-joints for that higher horsepower application.
Warranty Information
12-Month Limited Worldwide Warranty
Prop 65 Warning
This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.
Installation Guide
Our AI assistant generates a step-by-step guide for this product — covering installation, maintenance, and troubleshooting.
This AI-generated guide is for general reference only and does not constitute official Speedmaster product documentation. Always verify fitment, torque specifications, and safety requirements before installation.